Set Up Stripe Terminal Card Reader
Stripe Terminal lets cashiers take card payments on a physical reader directly from the Biznsbook POS. You need the POS module, your own Stripe account, an internet-connected reader (such as the BBPOS WisePOS E or Stripe Reader S700) and Stripe Terminal switched on for your company by Biznsbook. Bluetooth-only readers are not supported, and Stripe Terminal is available only in the countries Stripe supports for it.
Biznsbook never sees or stores card numbers. The reader talks to Stripe directly, and your money goes from Stripe to your own bank account. Set aside about twenty minutes. There is also a Setup guide button on the settings page.
Set it up
- Go to Sidebar → Integrations → Integration hub → Stripe Terminal, tick Enable this connector and click Save settings. Nothing changes at the till yet.
- Click Connect with Stripe, sign in and approve Biznsbook. The banner shows your connected account and whether you are in test mode or live mode. Start in test mode, where no real money moves.
- Pick the ledger account Stripe deposits into from Payout bank account. Biznsbook will not guess it. Until it is set, card payouts are recorded but not posted to your books, and the reconciliation page warns you.
- Under Locations, add one location per shop with its street address. Every reader belongs to a location.
- Register the reader. Power it on and connect it to the same internet as your till, open Settings → Generate pairing code on the reader, then type the code into Pairing code, give the reader a recognizable name, choose the location and click Register.
- In the Readers table, set Paired register to the POS register beside the reader. One reader belongs to one register.
- Click Test reader connection. You should see how many locations and readers were found. Then open the POS on that register; the reader connects on its own.
- Run practice sales in test mode. To go live, switch your Stripe account to live mode, reconnect at step 2 and register the reader again.
Turn it off
Untick Enable this connector and save, or click Disconnect. The till goes back to recording card payments as a note. Nothing already recorded changes.
:::info Taking payments, refunds and payouts Cashier steps, refunds, disputes and payout reconciliation are in Take card payments on a Stripe reader. Card payments cannot be taken or queued offline, though cash sales can. :::
Troubleshooting
| Symptom | Cause and fix |
|---|---|
| Connect with Stripe says Stripe is not configured, or shows "Invalid redirect URI" | Stripe Terminal is not fully set up on this installation. Contact Biznsbook support |
| Payouts recorded but not posted | The Payout bank account is not set. Set it, then click Post on each payout on the reconciliation page |
| No card reader found at the till | The reader is off, asleep or on a different network from the till |
| Shows as not connected after working before | Reconnect with Connect with Stripe and register the reader again |
For the exact error Stripe returned, see Sidebar → Integrations → Execution log.
Next step
Learn more about Biznsbook Integration Hub on biznsbook.com.